If you have a Chevy truck and the key switch is broken, you may wonder if there is a way to bypass it. This guide will show you how to do it in just a few simple steps.
Contents
Locate the Ignition Switch on Your Chevy Truck
The ignition switch is typically located on the steering column, near where the key goes in.
Remove the Ignition Switch
Remove the two screws that hold the switch in place using a screwdriver. Then, pull the switch out of the steering column.
Bypass the Ignition Switch
Connect the two wires that go to the ignition switch using a wire.
Test the Ignition Switch
Put everything back together and test it to ensure it works properly.
Why Do You Need to Bypass the Ignition Switch on a Chevy Truck?
The ignition switch is responsible for sending power to the starter. If it breaks, your truck won’t start. Bypassing the ignition switch allows you to start your vehicle without replacing the entire ignition system. However, it’s important to note that bypassing the ignition switch is only a temporary fix that should be used in emergencies.
Consult a Professional
It’s always best to consult a professional before bypassing the ignition switch. If you do it wrong, you could cause severe damage to your truck.
How Much Does It Cost to Bypass an Ignition Switch on a Chevy Truck
Having a professional bypass your ignition switch will cost between $100 and $200, but the cost may vary depending on the make and model of your truck.
What Is the Purpose of the Ignition Switch?
The ignition switch is responsible for sending power to the starter. Without it, your truck wouldn’t be able to start.
How to Bypass an Ignition Switch Without the Key?
If you need to bypass the ignition switch without the key, you can try a few methods. One option is to insert a screwdriver into the ignition lock cylinder and turn it in a clockwise direction while pulling the paperclip to the right. Another is to use a tension wrench to turn the ignition cylinder and insert a paperclip or small object to push it until the switch pops out.
How to Hotwire an Old Chevy Truck?
If you have an old Chevy truck and need to hotwire it, locate the ignition switch on the steering column, pry it off with a screwdriver, and use a paperclip or small object to push it out of the way.
How to Bypass the Anti-theft on a Chevy Silverado?
To bypass the anti-theft system on a Chevy Silverado, insert the ignition key and turn it to the on position, attempt to start the engine, leave the key in that position until the security light stops flashing, switch the ignition key to off, wait about five seconds, then try to start the engine again.
Conclusion
Bypassing the ignition switch on your Chevy truck is a simple process that can save you time and money in the short term. Still, replacing the switch as soon as possible is always best to avoid further damage.
